Common Misconceptions in Routine Maintenance of Deutz Engine Parts

The engine can not be separated from the daily careful maintenance, reasonable routine maintenance can effectively extend the service life of the product, enhance the efficiency of the product, so as to save money for the user. Deutz engine parts are also inseparable from the daily maintenance, this article will introduce you to the common misunderstandings in the daily maintenance of Deutz engine parts, in order to answer your questions.

(1) Even if you use good quality oil, the oil filter needs to be changed regularly. Some users think that as long as they use good quality oil, they don't need to change the oil filter regularly. This is not the case. Different grades of lubricating oil will change in the process of use, and the oil is not changed for a long period of time will lead to excessive accumulation of sludge in the crankcase. As the oil passes through the oil filter element, it accumulates solid particles and sludge from the oil in the filter. If the filter is clogged, the oil will not pass smoothly through the cartridge and will swell the cartridge or open the safety valve, resulting in faster engine wear and increased internal contamination. Therefore, regular replacement of the oil filter is very important.

(2) Cylinder head bolts, connecting rod bolts, balance block bolts, main bearing bolts belong to the important parts of the bolts, are high-strength bolts, do not install spring shims and thrust shims in the installation, overhaul period to check the cylinder head bolts and tensile deformation, the original length of the cylinder head bolts 211 ± 0.5mm, after the use of the length of the 212.5mm can not be used again, should be replaced with a new one, the connecting rod bolts in principle, is the best! In principle, the connecting rod bolts are best used once.

(3) Engine coolant temperature is not the lower the better. Engine coolant temperature is too low is a matter of concern, if the engine for a long time in low-temperature conditions, especially excessive cooling, not only a waste of heat will also cause the following adverse consequences: First of all, due to the cylinder wall temperature is too low will make the fuel evaporation is poor, the quality of combustion decreases, resulting in reduced engine power, increased fuel consumption; Secondly, due to the lubricating oil viscosity is too large, resulting in poor lubrication and wear of machine parts increased, and the engine temperature is too low, the engine temperature is too low. Wear and tear of the machine parts increased, in addition, the low temperature will also increase the cylinder corrosion wear. Therefore, the engine coolant temperature must be moderate, according to the regulations to maintain between 80 ℃ ~ 90 ℃.

(4) Dust in the air intake pipe also needs to be cleaned in time.If the vehicle is often traveling in the dusty, poor air quality areas, should pay attention to more clean up dust, timely replacement of air filters, when necessary, clean the intake pipe to ensure that the air intake smooth. If the intake pipeline is too dirty, it will lead to a decline in combustion efficiency, and aggravate the wear and aging of the engine.

The above is a few common misunderstandings in the daily maintenance and repair of Deutz engine parts. If you want to know more professional shopping information, you can go to the official website of Keluo Construction Machinery.

Keluo Construction Machinery manufactures and sells Deutz Engine Parts in large quantities, and every product is heavily inspected before shipping. We produce engine parts with good durability, long service life, and a wide range of products, so if you need them, browse our inventory now to find the best ones for you! Used machinery to increase your productivity and success. Experience the reliability and value that our machinery can bring to your project and look forward to working with you.